Black Box IC109A-R2 Instalační manuál stáhnout pdf (Strana 122)

116

Use

SFT2841 Software

Mimic-Diagram Editor

Use

PE50440

Setting Up Symbol Properties

You can personalize symbol properties in the "Symbol properties" window.

Four events comprise personalizing symbol properties:

1 Indicating the general symbol properties: name and description.

2 Modificating the symbol icon.

3 Modifying the graphic representations of symbol states.

4 Assigning the inputs/outputs linked to the symbol.

Modifying the Symbol Icon

The icon represents the symbol in the library of symbols.

1 Click the Modify button (3) to run the drawing software.

2 Modify the displayed icon as desired as long as the format (32 x 32 pixels) is

maintained.

3 Save the new icon and quit the drawing software before going on to the next step.

Modifying the Graphic Representations of Symbol States

The animated or controlled symbols are represented in the diagram in two or three

different states. A graphic representation corresponds to each state.

1 Click the Modify button (4) to run the drawing software.

2 Modify the symbol graphic as necessary.

3Save the new representation

4Quit the drawing software before going on to the next step.

Assigning Inputs and Outputs Linked to a Symbol.

The Modify button (5) opens the I/O assignment window used to assign a Sepam™

variable to each input and output of the symbol.

Proceed as follows to assign a symbol input:

1 Select a symbol input.

2 Select a Sepam™ input variable among the available inputs (it is not possible to

assign a Sepam™ output variable to a symbol input).

3 Click the Assign button to link the Sepam™ variable to the symbol input.

Use these same steps to assign a symbol output.

Definition of symbol properties:

1 Symbol name

2 Symbol description

3 Modify the icon

4 Modify the graphic representations of symbol states

5 Modify input/output assignments

6 Position and test the symbol in the diagram

PE50436

Input/output assignment

Creating Predefined Diagram Templates

You can save a personalized mimic-diagram as a template for later use. It is similar

to the predefined diagram templates in the IEC and ANSI diagram libraries.

Use the following steps to save a personalized diagram as a diagram template:

1 Select the File / Save As… command.

2 Open the directory \SDSMStudio\Template.

3 If necessary, create a personalized directory in addition to the existing \IEC and

\ANSI directories.

4 Enter the name of the diagram file with the .sst extension.

5 Set the type of file as "Document template (*.sst)".

6 Save the mimic diagram.

When the mimic-diagram editor runs, the new predefined diagram templates are

shown in the personalized directory or in the "Others" directory.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 163 164

Komentáře k této Příručce

Žádné komentáře

Black Box IC109A-R2 Instalační manuál Strana 122

Komentáře k této Příručce