Black Box ACS120 Uživatelská příručka stáhnout pdf (Strana 322)

100

101

Appendix C - The pslave Configuration File

322 BLACK BOX ® Advanced Console Server

conf.nat_clustering_ip IP address of any BLACK BOX ® Advanced

Console Server interface (master box). It is a

public IP address (e.g. Ethernet's interface IP

address) and it is the one that must be used to

connect the slave's serial ports. You can use

the same value assigned to the Ethernet's IP

address as that of the master box in the chain.

64.186.161.10

all.ipno This is the default IP address of the BLACK

BOX ® Advanced Console Server 's serial

ports. The “+” indicates that the first port

should be addressed as 192.168.1.101 and the

following ports should have consecutive val-

ues. Any host can access a port using its IP

address as long as a path to the address exists

in the host's routing table.

192.168.170.1

01+

all.netmask It defines the network mask for the serial port. 255.255.255.2

all.DTR_reset This parameter specifies the behavior of the

DTR signal in the serial port. If set to zero the

DTR signal will be ON if there is a connection

to the serial port, otherwise OFF. If set from 1

to 99 the DTR signal will be always ON. A

value greater or equal 100 specifies for how

long (in milliseconds) the DTR signal will be

turned off before it is turned back on again

when a connection to the serial port is closed.

100

all.break_

sequence

This parameter is the string that is used to

send a break to the TTY. It is only valid if TTY

protocol is socket_ssh or socket_server.

~break

all.break_interval This parameter defines the break duration in

miliseconds. It is valid if TTY protocol is

socket_ssh,

socket_

server or ssh-2

(client)

Table 27: Mostly CAS-specific Parameters

Parameter Description

Value for this

Example

1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 449 450

Komentáře k této Příručce

Žádné komentáře

Black Box ACS120 Uživatelská příručka Strana 322

Komentáře k této Příručce