Black Box ServSwitch Uživatelská příručka stáhnout pdf (Strana 12)

QUICK SETUP

1. Quick Setup

This section briefly describes how to install your KVM extender system and optimize the

video signals. Unless you are an experienced user, we recommend that you follow the full

procedures described in the rest of this manual.

Any Problems?

See Installation and

Troubleshooting sections.

Adjust Brightness and Focus controls

Optimize video quality on remote console monitor (See page

30)

Provides useful image for

adjusting video.

Serial Extender?

Yes

Set Baud Rate and Flow Control Jumpers

Set jumpers on remote and Local Units for required

baud rate and handshaking/flow control (see page

48). Adjustment is not required for most

lications.

Set Cable Length Jumpers

Remove Remote Unit cover and set all three jumpers to position

for Interconnect cable length (see page 19)

Install system

1. Connect Remote Unit to KVM and serial device (if

present).

2. Connect Local Unit or Extender hub to CPU.

3. Connect remote and Local Units with compatible CAT5/5e

Interconnect cable.

iew Test Card

ftp://ftp.blackbox.com/connectivity/ServSwitch/

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Žádné komentáře

Black Box ServSwitch Uživatelská příručka Strana 12