Black Box V5.1 Průvodce řešením problémů stáhnout pdf (Strana 5)

Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 EDL-IGN Page 5 of 43

www.EuroMotoElectrics.com info@euromotoelectrics.com Tel: 1-303-526-0901

EnDuraSpark Electronic Ignition

Installation & Troubleshooting v5.1

Place bike on center stand, flip open seat, and

remove tool box. The seat doesn't need to be

removed if it and the tank are stock.

Turn off both fuel petcocks and remove the gas

lines from the petcocks. If fitted, remove the gas

overflow line under the tank.

Tighten the steering damper (if equipped) so the front wheel remains

straight ahead.

Unscrew and remove the wing nuts (or on later year models, plastic

knurled nuts) at rear of tank. Lift rear of tank until the cross piece

clears the top of the two studs. Then slide tank back as far as possible

(about 1/2 inch). The front of the tank will now clear the front rubber

support.

Unless it is stuck on, remove the rubber front tank support (to

keep from losing it, it falls off easily).

With 5 mm Allen remove

front engine cover:

(Later models and R65s

only have the two top

bolts)

Step 5: Remove Front Engine Cover

Step 4: Remove Gas Tank

1 2 3 4 5 6 7 8 9 10 ... 42 43

Žádné komentáře

Black Box V5.1 Průvodce řešením problémů Strana 5