Black Box Switch PQ-8S Uživatelský manuál Strana 20

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 168
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 19
21
PQ-8P, PQ-8S
Table 4-1. Recommended Emulation and Device ID for the Host
Systems.
Host System Printer Used Emulation Device ID
S/38, S/36 Laser printer (using 3812 5219
HP PCL commands)
S/38, S/36 Matrix printer 4214 4214-2
(printing NLQ)
S/38, S/36, Matrix printer 5224 5224 (2P)
(S/34)
S/38, S/36, Specialty printer (e.g. 5256 5256
S/34 label printer)
4.2.1 S
WITCH
S
ETTINGS
Use the PQ-8’s configuration
switches to select the twinax address,
the output protocol, and to perform
the available test and diagnostic
functions. The PQ-8S has a second
bank of eight switches (referred to
as SW2) to change the serial
parameters. Use a pointed object,
such as a ball-point pen, to change
the switch settings.
When operating, the PQ-8 will
only recognize EBCDIC Hex Dump
and ASCII Hex Dump settings. All
other settings are only read at power-
up. Whenever one of these settings is
changed, remember to cycle power
to activate them.
NOTE
Check the device description.
Host Print Transform must be
turned “Off” in OS/400 V2R3
and later.
4.2 PQ-8 Configuration
The PQ-8 can be configured
through its on-board configuration
switches, user-friendly PC setup
software, or by sending download
commands from the host or from a
PC/LAN. To ensure proper
functioning of the PQ-8, you should
review all available setup parameters.
Zobrazit stránku 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 167 168

Komentáře k této Příručce

Žádné komentáře